SkyBell HD Wedge Mount is used to adjust the angle of the SkyBell HD Wi-Fi Video Doorbell device to provide optimal viewing. Installing the SkyBell HD Wedge Mount (Optional) Turn the screw to the right until tight but do not over-tighten the set screw. Tighten the set screw on the bottom of the mounting plate.If the LED does not come on, remove the SkyBell and ensure the wires are properly attached to the mounting plate. Hold the device in place until the LED illuminates.Note: The SkyBell HD may not be flush with the customer’s home, this is okay. Snap the bottom into place until it is flush with the mounting plate.Attach the top of the SkyBell HD to the lip first, tipping it up slightly to ensure it is attached.Locate the lip on the top of the mounting plate.Give each wire a slight tug to be sure each is secure. Insert one wire under each screw and tighten.Loosen the two screws slightly to allow for the ends of the wires to pass underneath.Install the mounting plate using the included screws and tighten until snug.Pull the wires through the center of the plate being careful not to touch the two wires together.

Place the SkyBell HD mounting plate onto the home, lining up the holes with the mounting plate and ensuring that the screws are facing forward.If the drill holes are too large, use the included screw anchors to provide the perfect fit for the screws. If installing into wood, use the included screwdriver and screws to start the holes. If installing into concrete, brick or stucco, use a power drill, with the included drill bit to make the holes for the screws.Mark the location (this step is unnecessary if the screw holes from the existing doorbell match). Use the mounting plate as a guide and determine where the screws will be placed.Leave the wires exposed and separate them from each other to prevent the wires from touching and activating the door chime.

Install skybell hd